Archive for Colchester Model Car Club RC Model Car Racing In Colchester
 


       Colchester Model Car Club Forum Index -> Mugen
CuttingEdge

Good Setup For Colchester ?

Any one got a good setup around colchester ???????????

For an MTX4 ?????????
CuttingEdge

Don't Think I need one now      

Well after 4 hours down at Snetterton today all I can say is WOW .......

It took 2 minutes to tune the engine , all it needed was the low speed needle wound in until it stopped spitting fuel out the Pipe and then it was fine ...........

After I had done about 5 tanks of fuel I decided to time it to see how long I could run on a tank , The answer was not good I could only get 7 mins 20 sec top wack But at least it was concistant as I did another 5 runs timed and they was all around the 7 min mark !!!! NOT ENOUGH as I need to be able to do 7mins 30 secs with ease or I will be needing to do 2 fuel stops compaired to others that I know can do a 15 min final on 1 stop   ....

So I tried leaning the TOP END SCREW down to hopfuly use less fuel BUT it did not like the 1/8th of a turn I gave it , It did not run a smooth as it had before so I presume I had got it about right in the first place !!!!

After doing this the Car would not restart for the next run ten minutes later , Having checked it over I found that the Glow Plug had Blown ( If this is the correct term ) Also having taken the glow plug out it turned out to be a standard plug , I thought it was a turbo Engine & Pipe BUT maybe it is not , So the Turbo Plug I had bought for a spare I felt I should not fit incase I caused any Damage !!!

I went to the Shop to buy a new number 6 plug BUT there plugs were colour coded and the Bloke behind the counter could not tell me what colour was equivelent to a number 6 ........ Hope less if you ask me .................

I had an old Plug in the pit box from and old Nitro thing I had 4 or 5 years back so i put it in not knowing what it was and I was off again for another 4 or 5 tanks worth of fuel  BUT it was not as smooth as it had been with the origanal plug in it ...

Well over all I did a lot of running with out cutting out at all all day and I only crashed once when I got a bit sloppy , only maybe 3 spins all that is left to say is

ITS FANTASTIC

And if Ryk is right and it will be loads better with softer springs on I can't wait to get them as this thing was planted all day long when it was damp , damp / drying & totaly dry ................

I am still smiling now & I was all the way home

Can't wait to go up against you seasoned Nitro Boys Now its sorted and the confidence is High ...........................
Mr.B

       Colchester Model Car Club Forum Index -> Mugen
Page 1 of 1